Keysight Technologies J-BERT M8020A - Page 406

406 Keysight M8070A Programming Guide
5 SCPI Command Reference
:PLUGin:EDIagram:FETCh[:RESult]:AMPLitude?
Syntax :PLUGin:EDIagram:FETCh[:RESult]:AMPLitude? ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name.
Description This command returns the eye amplitude which is the difference between
the mean logic 1 level values and the mean logic 0 level values in a
histogram of an eye diagram.
This SCPI is applicable for M8041A, M8051A and M8062A.
Example :PLUG:EDI:FETC:AMPL? ‘MyMeasurement’
:HEIGht? :PLUGin:EDIagram:FETCh[:RESult]:HEIGht? on page 408
:HILevel? :PLUGin:EDIagram:FETCh[:RESult]:HILevel? on
page 408
:JPPeak?
:PLUGin:EDIagram:FETCh[:RESult]:JPPeak? on
page 408
:JRMSquare? :PLUGin:EDIagram:FETCh[:RESult]:JRMSquare? on
page 409
:LOLevel?
:PLUGin:EDIagram:FETCh[:RESult]:LOLevel? on
page 409
:RISetime? :PLUGin:EDIagram:FETCh[:RESult]:RISetime? on
page 409
:SCOunt? :PLUGin:EDIagram:FETCh[:RESult]:SCOunt? on
page 410
:SNRatio? :PLUGin:EDIagram:FETCh[:RESult]:SNRatio? on
page 410
:WIDTh? :PLUGin:EDIagram:FETCh[:RESult]:WIDTh? on page 410
Name Description under