AKD2G-S Installation, Safety 1 | 9 īīSetup
9.2.2 Setup software WorkBench
This chapter describes the installation of the setup software WorkBench for AKD2G drives.
Kollmorgen offers training and familiarization courses on request.
9.2.2.1 Use as directed
The setup software is intended to be used for altering and saving the operating parameters for
the AKD2G series of drives. The attached drive can be set up with the help of this software,
and during this procedure the drive can be controlled directly by the service functions.
Only professional personnel who have the relevant expertise (ā # 15) are permitted to carry
out online parameter setting for a drive that is running.
Sets of data that have been stored on data media are not safe against unintended alteration
by other persons. Unexpected move could be the result if you use unchecked data. After load-
ing a set of data you must therefore validate parameters which are relevant for the application
before enabling the drive.
116 Kollmorgen | kdn.kollmorgen.com | Beta, December 2018
To Next Page
Loading...
Need help?
General
