348| Customizing, recording and editing the Songs
Transposing
The transpose function may be used to transpose the selected track(s).
1 Go to the Sequencer > Song Edit > Transpose page.
2 Select the Track to edit.
Track Meaning
All All tracks selected, apart for the tracks set in Drum mode (like the
Drum and Percussion tracks).
Track 1 … 16 Selected track.
3 Use the Value parameter to choose the transpose value.
Value Meaning
-127 … 127 Transpose value (in semitones)
4 Use the Start Tick and End Tick parameters to set the beginning and ending
of the phrase to be transposed.
If a phrase is four measures long, and you want to select it all, the Start will
be positioned at 1.01.000, and the End at 5.01.000.
5 Use the Bottom Note and Top Note parameters to set key range to trans-
pose.
If you select the same note as the Bottom and Top parameters, you can se-
lect a single percussive instrument in a Drum Kit. Since in a Drum Kit each
instrument is assigned to a different note of the scale, transposing a percus-
sive instrument means assigning the part to a different instrument.
Selective transpose can also be used to avoid transposing RX Noises (trans-
posing only notes under C7).
To Next Page
Loading...
