Setting up the pedals, audio connections, music stand |17
Use either the LEFT or RIGHT connector to output a mono signal.
Adjust the output level with the MASTER VOLUME knob.
If they are not deactivated, the integrated speakers will work in parallel with
the main audio outputs.
Installing the music stand
A music stand comes with your Pa1000. Insert its legs into the two dedicated
holes on the rear panel, as shown in the following illustration. Please note
that the latest 0,5 cm (0.2”) require more strength to fit. Push harder, until
you feel a ‘click’ and the legs are completely inserted.
To Next Page
Loading...
