Using the effects and voice harmonization |527
Controlling the Voice/Guitar Processor via MIDI
You can control the Voice/Guitar Processor via MIDI, for example by con-
necting a MIDI pedalboard to the MIDI IN port of Pa1000.
Choosing a MIDI channel
The controlling device must transmit on the MIDI channel selected as the
Voice/Guitar Processor’s MIDI channel.
1 Go to the Global > Midi > Midi In Control page.
2 Use the Voice/Guitar Processor > Channel parameters to select one of the
MIDI channels.
3 Use the Voice Processor > Octave Transpose In parameter to transpose the
chords or notes received.
4 Use the Voice Processor > In Note Range High/Low parameters to set a
range or notes to be sent to the Harmony section of the Voice Processor.
To Next Page
Loading...
