Korg PA1000

562| Effects for the Sounds, Voice, Guitar
Reverb Dry Plate
This plate reverb simulates dry (light) reverberation.
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Stereo Out / FX Amt = 0: Stereo In - Stereo Out
EQ Trim
+
EQ Trim
LEQ HEQ
Pre Delay
Reverb
Pre Delay Thru
a Reverb Time [sec] 0.1…10.0 Sets the reverberation time
High Damp [%] 0…100 Sets the damping amount in the high range
b Pre Delay [msec] 0…200 Sets the delay time from the dry sound
Pre Delay Thru [%] 0…100 Sets the mix ratio of non-delay sound
c EQ Trim 0…100 Sets the EQ input level
d Pre LEQ Fc Low,
Mid-Low
Selects the cutoff frequency (low or mid-
low) of the low-range equalizer
Pre HEQ Fc High,
Mid-High
Selects the cutoff frequency (high or mid-
high) of the high-range equalizer
e Pre LEQ Gain [dB] –15.0…+15.0 Sets the gain of Low EQ
Pre HEQ Gain [dB] –15.0…+15.0 Sets the gain of High EQ
f Wet/Dry Dry,
1:99…99:1, Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
b: Pre Delay [msec]
b: Pre Delay Thru [%]
The “Pre Delay” sets the delay time to the reverb input, allowing you to con-
trol spaciousness.