Korg PA1000

Effect parameters |565
Early Reflections
This effect is only the early reflection part of a reverberation sound, and
adds presence to the sound. You can select one of the four decay curves.
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Stereo Out / FX Amt = 0: Stereo In - Stereo Out
EQ Trim
+
EQ Trim
Pre Delay
Early Reflections
LEQ HEQ
a Type Sharp, Loose,
Modulated,
Reverse
Selects the decay curve for the early
reflection
b ER Time [msec] 10…800 Sets the time length of early reflection
c Pre Delay [msec] 0…200 Sets the time taken from the original
sound to the first early reflection
d EQ Trim 0…100 Sets the input level of EQ applied to the
effect sound
e Pre LEQ Fc Low,
Mid-Low
Selects the cutoff frequency (low or
mid-low) of the low-range equalizer
Pre HEQ Fc High,
Mid-High
Selects the cutoff frequency (high or
mid-high) of the high-range equalizer
f Pre LEQ Gain [dB] –15.0…+15.0 Gain of the Low EQ
Pre HEQ Gain [dB] –15.0…+15.0 Gain of the High EQ
g Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source