462| Customizing and editing the Sounds
Editing the samples
After recording, loading or importing, you can edit the samples.
▪ Go to the Sampling > Edit page.
This page allows you to cut, trim or normalize a sample, as well as edit the
loop points. The sample can be played over the full keyboard.
Choosing the sample to edit
1 Touch the name of the sample on top of the page to open the Sample Select
window.
2 Touch the name of a sample to select it.
Reading the sample waveform diagram
The diagram shows the sample’s waveform evolving during time (x-axis), and
its changing amplitude (y-axis). It also shows the Start, End and Loop points.
The area included between the Start and End points appears highlighted.
To Next Page
Loading...
