482| Customizing and editing the Sounds
Creating new Sounds from multisamples
You can create a new Sound while in Sound mode.
1 Go to the Sound mode.
2 Choose a Sound similar to the one you are going to create.
If you prefer to start from a blank, default situation, choose the Initialize
Sound command from the page menu.
3 Go to the Sound > Basic > OSC page.
4 Select one of the available oscillators from the radio buttons on the right
side of the page.
5 Use the parameters in the OSC Multisample section to assign the multisam-
ple to the High or Low layer of the selected oscillator. Your new multisample
can be found in the RAM bank of multisamples.
6 Go on editing the Sound, as shown in the pages dedicated to Sound editing.
To Next Page
Loading...
