Korg PA1000

Effect parameters |755
Auto Reverse
This effect records the input signal and automatically plays it in reverse (the
effect is similar to a tape reverse sound).
Input
D-mod
Envelope Select
D
-mod
Envelope Control
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
+
Auto Reverse
Direct
Mix
Rec/Reverse Play
Control
a Rec Mode Single, Multi Sets the recording mode
b Reverse Time
[msec]
20…2640 Sets the maximum duration of the reverse play-
back
c Envelope Select D-mod, Input Selects whether the start and end of recording
is controlled via the modulation source or the
input signal level
Src Off…Tempo Selects the modulation source that controls re-
cording when Envelope Select is set to D-mod
d Threshold 0…100 Sets the recording start level when Envelope
Select is set to Input
e Response 0…100 Sets the speed of the response to the end of
recording
f Direct Mix Always On,
Always Off,
Cross Fade
Selects how a dry sound is mixed
g Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
a: Rec Mode
b: Reverse Time [msec]
When “Rec Mode” is set to Single, you can set up to 2,640msec for “Reverse
Time.” If recording starts during the reverse playback, the playback will be
interrupted.