494| Customizing and editing the Sounds
Using the Audio Groove Slices in other
Sounds
You can use the multisample and samples generated by a Time Slicing op-
eration in other Sounds.
1 Go to the Sound mode, and choose a Sound similar to the one you want to
assign the multisample to.
If you prefer to start from blank programming, choose the Initialize Sound
command from the page menu.
2 Go to the Sound > Basic > OSC page, and select one of the oscillators.
3 Choose the new multisample from the RAM area, and assign it to one of the
two layers (High or Low).
4 Choose the Write Sound command from the page menu, and save the Sound
to an empty User location.
To Next Page
Loading...
