Creating text files (lyrics) |369
Setting the language on the Pa
To correctly read text on your Pa, be sure to set the Language parameter to
your language. This can be done in the Global > General Controls > Interface
page.
1 Since the instrument must be restarted at the end of this procedure, be sure
to first save any unsaved data.
2 While in the Interface page, select a language from the popup menu.
3 The Change command will start flashing. Touch it.
4 A message will ask you to reboot the instrument. Touch OK to close the mes-
sage window.
5 Turn the instrument off, then on again.
Editing the TXT file on a Windows PC
1 Launch Notepad++.
2 Open the original TXT file.
3 Choose File > New to open a new tabbed window containing the new TXT file.
4 Choose Encoding > Character sets > [Your Language] > [Encoding].
5 Click on the tab containing the original TXT file.
To Next Page
Loading...
