Editing the Sounds |413
Controlling the LFO
Use the LFO 1/2 parameters to controls the LFO (Low Frequency Oscillation)
on the selected oscillators. LFO generators are programmed in the Sound
Edit > LFO > LFO 1 and LFO 2 pages.
▪ Use the LFO 1/2 Int parameter to set the intensity (-12…0…+12) of the cor-
responding LFO. Negative values will invert the LFO shape.
▪ Use the JS+Y parameter to set the intensity (-12…0…+12) of the correspond-
ing LFO when the joystick is pushed forward. Negative values will invert the
LFO shape.
▪ Use the AMS and Intensity parameters to choose an AMS to modulate the
corresponding LFO, and the intensity of the modulation.
To Next Page
Loading...
