Korg PA1000 - Page 589

Effect parameters |577
St. Dynamic Delay (Stereo Dynamic Delay)
This stereo delay controls the level of delay according to the input signal
level. You can use this as a ducking delay that applies delay to the sound only
when you play keys at a high velocity or only when the volume level is low.
Delay
Left
Right
Feedback
Spread
FX Amt
FX Amt
Stereo In - Stereo Out
High Damp Low Damp
High Damp
Low Damp
Threshold
Delay
FB
Out
Control Target
Attack, Release
Envelope
+
a Control Target None, Out, FB Selects from no control, output, and feed-
back
Polarity +, – Reverses level control
b Threshold 0…100 Sets the level to which the effect is ap-
plied
Offset 0…100 Sets the offset of level control
c Attack 1…100 Sets the attack time of level control
d Release 1…100 Sets the release time of level control
e L Delay Time [msec] 0.0…1360.0 Sets the delay time for the left channel
f R Delay Time [msec] 0.0…1360.0 Sets the delay time for the right channel
g Feedback –100…+100 Sets the feedback amount
h High Damp [%] 0…100 Sets the damping amount in the high
range
Low Damp [%] 0…100 Sets the damping amount in the low range
i Spread –100…+100 Sets the width of the stereo image of the
effect sound
j Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source