Korg PA1000 - Page 596

584| Effects for the Sounds, Voice, Guitar
a BPM MIDI,
40.00…
300.00
MIDI syncs to the system tempo; 40–300 sets the
tempo manually for this individual effect
Time Over? ---, OVER! Displays an error message when the delay time ex-
ceeds the upper limit
b L Delay Base
Note
…
Selects the type of notes to specify the delay time
for TapL
Times x1…x32 Sets the number of notes to specify the delay time
for TapL
Level 0…50 Sets the output level of TapL
c C Delay Base
Note
…
elects the type of notes to specify the delay time
for TapC
Times x1…x32 Sets the number of notes to specify the delay time
for TapC
Level 0…50 Sets the output level of TapC
d R Delay Base
Note
…
Selects the type of notes to specify the delay time
for TapR
Times x1…x32 Sets the number of notes to specify the delay time
for TapR
Level 0…50 Sets the output level of TapR
e Feedback
(C Delay)
–100…+100 Sets the feedback amount of TapC
Src Off…Tempo Selects the modulation source for the TapC feed-
back
Amt –100…+100 Sets the modulation amount of the TapC feedback
f High Damp [%] 0…100 Sets the damping amount in the high range
Low Damp [%] 0…100 Sets the damping amount in the low range
g Input Level
Dmod [%]
–100…+100 Sets the modulation amount of the input level
Src Off…Tempo Selects the modulation source for the input level
h Spread 0…50 Sets the width of the stereo image of the effect
sound
i Wet/Dry Dry,
1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source