Korg PA1000 - Page 598

586| Effects for the Sounds, Voice, Guitar
d L Feedback –100…+100 Sets the feedback amount for the left channel
Src Off…Tempo Selects the modulation source of feedback amount
Amt L –100…+100 Sets the modulation amount of the left channel
feedback
e R Feedback –100…+100 Sets the feedback amount for the right channel
Amt R –100…+100 Sets the modulation amount of the right channel
feedback
f High Damp [%] 0…100 Sets the damping amount in the high range
g Low Damp [%] 0…100 Sets the damping amount in the low range
h Input Level
Dmod [%]
–100…+100 Sets the modulation amount of the input level
Src Off…Tempo Selects the modulation source for the input level
i Wet/Dry Dry,
1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
a: Time Over? L, R
You can set the delay time up to 2,730msec. If the delay time exceeds this
limit, the error message “OVER!” appears in the display. Set the delay time
parameters so that this message will not appear. “Time Over?” is only a
display parameter.