Korg PA1000

588| Effects for the Sounds, Voice, Guitar
g High Damp [%] 0…100 Sets the damping amount in the high range
Low Damp [%] 0…100 Sets the damping amount in the low range
h Input Level Dmod
[%]
–100…+100 Sets the modulation amount of the input
level
Src Off…Tempo Selects the modulation source for the in-
put level
i Spread –100…+100 Sets the width of the stereo image of the
effect sound
Src Off…Tempo Selects the modulation source of the effect
sound’s stereo image width
Amt –100…+100 Sets the modulation amount of the effect
sound’s stereo image width
j Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
St.BPM Mod. Delay (Stereo BPM Modulation Delay)
This is a stereo modulation delay that lets you synchronize the delay time to
the tempo of the song.
Tempo
BPM
BPM
Base Note x Times
Base Note x Times
Left
Right
Feedback
LFO Phase
FX Amt
FX Amt
Stereo In - Stereo Out
LFO: Tri / Sine
Modulation Mode
D-mod
LFO
D
-mod
Delay
Delay
L/R: +/+ +/–
LFO Shape
Response
LFO Sync