610| Effects for the Sounds, Voice, Guitar
g Feedback –100…+100 Sets the feed back amount of the chorus
block
High Damp [%] 0…100 Sets the high range damping amount of the
chorus block
h Low Level 0…100 Sets the low range output level
High Level 0…100 Sets the high range (chorus) output level
i Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
f: High/Low Split Point
This parameter sets the frequency that splits the high and low range. Only
the high range will be sent to the chorus block.
g: Feedback
Sets the feedback amount of the chorus block. Increasing the feedback will
allow you to use the effect as a flanger.
To Next Page
Loading...
