Korg PA1000

Effect parameters |623
f Manual 0…100 Sets the frequency to which the effect is ap-
plied
Src Off…Tempo Selects the modulation source for the LFO
modulation
Amt –100…+100 Sets the modulation amount of the LFO modu-
lation
g Depth 0…100 Sets the depth of LFO modulation
h Resonance –100…+100 Sets the resonance amount
High Damp [%] 0…100 Sets the resonance damping amount in the
high range
i Wet/Dry -Wet, -1:99…
Dry…99:1, Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
St. Env. Phaser (Stereo Envelope Phaser)
This stereo phaser uses an envelope generator for modulation. You will ob-
tain the same pattern of phasing each time you play. You can also control the
Phaser directly using the modulation source.
EG Attack/Decay
EG
D-mod
Sweep Mode
D
-mod
Phaser
Phaser
Left
Right
Resonance
FX Amt
FX Amt
High Damp
Stereo In - Stereo Out
a L Manu Bottom 0…100 Sets the lower limit of the frequency range for
the effect on the left channel
L Manu Top 0…100 Sets the upper limit of the frequency range for
the effect on the left channel
b R Manu Bottom 0…100 Sets the lower limit of the frequency range for
the effect on the right channel
R Manu Top 0…100 Sets the upper limit of the frequency range for
the effect on the right channel