Effect parameters |625
Orange Phaser
This phaser pedal is a favorite on many recordings. It’s useful for adding
sparkle, animating chord passages, and widening and fattening the sound.
The original had only a speed control; this version adds depth, control of the
center frequency, and more.
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Phaser
LFO
Resonance
a Speed 0.10…10.00 This controls the speed of the phaser’s LFO.
Src Off…Tempo Selects a modulation source for LFO speed
Amt –20.00…
+20.00
Sets the modulation amount of LFO speed
b Depth 0…100 Sets the depth of LFO modulation
Src Off…Tempo Selects the modulation source for the LFO
modulation depth
Amt –100…+100 Sets the modulation amount of the LFO
modulation depth
c Resonance –100…+100 This controls the intensity of the phaser ef-
fect. The default is 26. Mixing the processed
and dry signals via Wet/Dry will enhance the
effect.
d Manual 0…100 Sets the frequency to which the effect is ap-
plied
e Wet/Dry -Wet, -1:99…
Dry…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
To Next Page
Loading...
