Effect parameters |629
c MIDI Sync Off, On When this is on, the LFO speed is set
by BPM, Base Note, and Times, instead
of Frequency
BPM MIDI,
40.00…
300.00
MIDI syncs to the system tempo; 40–
300 sets the tempo manually for this
individual effect
Base Note
…
Selects the type of notes that specify
the LFO speed
Times x1…x32 Sets the number of notes that specify
the LFO speed
d Phaser Manual 0…100 Sets the phaser frequency range
Resonance –100…+100 Sets the phaser resonance amount
e Phaser Depth 0…100 Sets the phaser modulation depth
Src Off…Tempo Selects the modulation source for the
phaser modulation depth
Amt –100…+100 Sets the modulation amount for the
phaser modulation depth
f Phaser Wet/Dry –Wet, –2 : 98…
Dry… 2 : 98, Wet
Sets the balance between the phaser
effect and dry sounds
g Tremolo Shape –100…+100 Sets the degree of the tremolo LFO
shaping
h Tremolo Depth 0…100 Sets the tremolo modulation depth
Src Off…Tempo Selects the modulation source for the
tremolo modulation depth
Amt –100…+100 Sets the modulation amount of the
tremolo modulation depth
i Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry
signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
a: Type
a: LFO Phase [degree]
Select the type of phaser LFO and tremolo LFO for the “Type” parameter.
How the effect sound moves or rotates depends on the type of LFO. Select-
ing “LFO Phase” enables you to offset the timing of the phaser peak and
control a subtle movement and rotation of the sound.