Effect parameters |703
a Mic Type Vintage Dynamic, Multi
Condenser, Percussion
Condenser, Drums
Dynamic,
Vocal Dynamic,
Multi Dynamic, Vocal
Condenser, Vocal Tube,
Kick Dynamic
Selects the type of mic
b Mic Position Close, On, Off, Far Sets the mic placement dis-
tance
c Tube Low Cut [Hz] Thru, 21…8.00k Sets the frequency of the low
cut filter
High Cut [Hz] 53…20.00k, Thru Sets the frequency of the high
cut filter
d Tube Gain [dB] –24.0…+24.0 Sets the input gain to the vacu-
um tube preamp
Saturation [%] 0…100 Sets the input/output re-
sponse of the preamp
e Tube Bias 0…100 Sets the bias level of the pre-
amp
f Tube Output Level [dB] –48.0…+0.0 Sets the output level of the
preamp
g Wet/Dry Dry, 1:99…99:1, Wet Balance between the wet and
dry signal
Src Off…Tempo See DMS (Dynamic Modulation
Source)
Amt –100…+100 Amount of modulation source
b: Mic Position
This expresses the effect that the mic position has on the sound. The Close
setting is the closest mic position, and the Far setting is the farthest.
To Next Page
Loading...
