Effect parameters |711
a Frequency Bottom 0…100 Sets the lower limit of the wah center fre-
quency
Frequency Top 0…100 Sets the upper limit of the wah center
frequency
b Sweep Mode Auto, D-mod,
LFO
Selects the control from auto-wah, mod-
ulation source, and LFO
Src Off…Tempo Selects the modulation source for the
wah when Sweep Mode=D-mod
Respon 0…100 Sets the response speed when Sweep
Mode = Auto or D-mod
c Envelope Sens 0…100 Sets the sensitivity of auto-wah
Envelope Shape –100…+100 Sets the sweep curve of auto-wah
d LFO Frequency [Hz] 0.02…20.00 Sets the speed of the LFO
Src Off…Tempo Selects a modulation source for LFO
speed
Amt –20.00…
+20.00
Sets the modulation amount of LFO
speed
e MIDI Sync Off, On When this is on, the LFO speed is set by
BPM, Base Note, and Times, instead of
Frequency
BPM MIDI,
40.00…
300.00
MIDI syncs to the system tempo; 40–300
sets the tempo manually for this individ-
ual effect
Base Note
…
Selects the type of notes that specify the
LFO speed
Times x1…x32 Sets the number of notes that specify the
LFO speed
f Resonance 0…100 Sets the resonance amount
Low Pass Filter Off, On Switches the wah low pass filter on and
off
g Output Level 0…100 Sets the output level of the effect sound
Src Off…Tempo Selects the modulation source that will
control the effect output level
Amt –100…+100 Sets the modulation amount of the effect
output level
h Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source