Effect parameters |737
a: Duration
c: LFO Sample Cycle [Hz]
Duration sets the length of the sampled grain, and the LFO Sample Cycle
controls how often a new grain is sampled. In between Sample Cycles, the
current grain is repeated continuously.
In
Out
Sample Cycle
Duration
Detune
Using this effect, you can obtain a detune effect that offsets the pitch of
the effect sound slightly from the pitch of the input signal. Compared to the
chorus effect, a more natural sound thickness will be created.
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
Input Level
Input Level
+
High Damp
Delay
Feedback
Detune
a Pitch Shift [cents] –100…+100 Sets the pitch difference from the input
signal
Src Off…Tempo Selects a modulation source for pitch shift
Amt –100…+100 Sets the modulation amount for pitch
shift
b Delay Time [msec] 0…1000 Sets the delay time
c Feedback –100…+100 Sets the feedback amount
High Damp [%] 0…100 Sets the damping amount in the high
range
To Next Page
Loading...
