Korg PA1000 - Page 771

Effect parameters |759
P4EQ
a [E]Trim 0…100 Sets the parametric EQ input level
b [E]B1 Cutoff [Hz] 20…1.00k Sets the center frequency of Band 1
Q 0.5…10.0 Sets the bandwidth of Band 1
Gain [dB] –18…+18 Sets the gain of Band 1
c [E]B2 Cutoff [Hz] 50…5.00k Sets the center frequency of Band 2
Q 0.5…10.0 Sets the bandwidth of Band 2
Gain [dB] –18…+18 Sets the gain of Band 2
d [E]B3 Cutoff [Hz] 300…10.00k Sets the center frequency of Band 3
Q 0.5…10.0 Sets the bandwidth of Band 3
Gain [dB] –18…+18 Sets the gain of Band 3
e [E]B4 Cutoff [Hz] 500…20.00k Sets the center frequency of Band 4
Q 0.5…10.0 Sets the bandwidth of Band 4
Gain [dB] –18…+18 Sets the gain of Band 4
PHASER
f [P]LFO Frequency [Hz] 0.02…20.00 Sets the speed of the LFO
LFO Waveform Triangle, Sine Selects the LFO Waveform
g [P]Manual 0…100 Sets the frequency to which the effect
is applied
Depth 0…100 Sets the depth of LFO modulation
Resonance –100…+100 Sets the resonance amount
h [P]Phaser Wet/Dry -Wet, -1:99…
Dry…99:1, Wet
Sets the phaser effect balance
Src Off…Tempo Selects the Wet/Dry modulation
source for the phaser
Amt –100…+100 Sets the Wet/Dry modulation amount
for the phaser
i [P]Output Mode Normal,
Wet Invert
Selects the phaser output mode
j Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry sig-
nal
Src Off…Tempo See DMS (Dynamic Modulation
Source)
Amt –100…+100 Amount of modulation source