Korg PA1000 - Page 799

Effect parameters |787
i [D]Mt.DelayWet/Dry Dry, 1:99…99:1, Wet Sets the multitap delay effect
balance
Src Off…Tempo Selects the Wet/Dry modula-
tion source for the multitap
delay
Amt –100…+100 Sets the Wet/Dry modulation
amount for the multitap delay
j Wet/Dry Dry, 1:99…99:1, Wet Balance between the wet and
dry signal
Src Off…Tempo See DMS (Dynamic Modulation
Source)
Amt –100…+100 Amount of modulation source
Multitap Cho/Delay (Multitap Chorus/Delay)
This effect has six chorus blocks with different LFO phases. You can produce
a complex stereo image by setting a different delay time and depth for each
block. You can control the delay output level via a modulation source.
Left
Right
Feedback
FX Amt
FX Amt
FX Amt = 100: Mono In - Stereo Out / FX Amt = 0: Stereo In -Stereo Out
+
LFO: Triangle
0 [degree]
180 [degree]
60 [degree]
240 [degree]
120 [degree]
300 [degree]
Tap1 Delay
Tap2 Delay
Tap3 Delay
Tap5 Delay
Tap6 Delay
Tap4 Delay
D
-mod
On/Off Control
Panning Preset
a LFO Frequency [Hz] 0.02…13.00 Sets the speed of the LFO
b Tap1 (000) [msec] 0…2000 Sets the Tap1 (LFO phase=0 de-
grees) delay time
Depth 0…30 Sets the Tap1 chorus depth
Status Always On, Always Off,
On›Off (Dm), Off›On
(Dm)
Selects on, off, or modulation
source for the control of Tap1
output