Korg PA1000

Effect parameters |789
i Tap1 Feedback –100…+100 Sets the Tap1 feedback amount
Src Off…Tempo Selects the modulation source
for the Tap output level, feed-
back amount, and effect balance
Amt –100…+100 Sets the modulation amount of
Tap1 feedback amount
j Wet/Dry Dry, 1:99…99:1, Wet Balance between the wet and
dry signal
Src Off…Tempo See DMS (Dynamic Modulation
Source)
Amt –100…+100 Amount of modulation source
b, c, d, e, f, g: Status
These parameters set the output status of each Tap.
Always On: Output is always on. (No modulation)
Always Off: Output is always off. (No modulation)
On/Off (dm): Output level is switched from on to off depending on the modu-
lation source.
Off/On (dm): Output level is switched from off to on depending on the modu-
lation source.
Combining these parameters, you can change from 4-phase chorus to two-
tap delay by crossfading them gradually via the modulation source during a
performance.
h: Panning Preset
This parameter selects combinations of stereo images of the tap outputs.