Kurzweil Flash Play PC4 - Velocity Track; Retrig Threshold; Random; Note Attack

Program Edit Mode
KB3 Editor: The KEYCLICK Page
3-116
Volume
is parameter sets the level of the keyclick; the noise decays from the level you set here. is
level is scaled by the drawbar levels, as well as the expression pedal level.
Decay
is parameter sets the basic decay time of the noise envelope. Smaller values produce a
shorter burst.
Velocity Track
is parameter controls the degree to which key velocity aects the key click volume. A
value of zero means that the key velocity has no eect on the key click volume (which is like
a real tone wheel organ). Other values add volume as the velocity increases. is parameter
typically only applies when playing a KB3 program from an external MIDI device.
Pitch
is parameter sets the basic pitch of the key click noise, relative to the highest tone wheel’s
pitch. e pitch is controlled by a steep lowpass lter applied to white noise. e lter’s cut
o frequency is controlled relative to key number, higher keys move the cuto frequency up,
lower keys move the cuto frequency down.
Random
is parameter controls the degree to which a random amount of amplitude variation is
added to the key click.
Retrig Threshold
is parameter lets you set the volume level below which key click must decay before it will
be retriggered.
Note Attack
is parameter controls the attack characteristic of notes. Normal provides a smoothed
attack, while a setting of Hard has an instant attack and will produce an audible click, in
addition to any amount of key click specied with the other parameters on this page (you
might prefer not to specify any additional key click when you use this setting). PercHard sets
a hard attack level for percussion only; notes without percussion use a normal attack.