Kurzweil Flash Play PC4 - Change Multis; Bank Select

Global Mode
MIDI Page
9-23
If you want make use of the PC4‘s sounds and use it as a MIDI controller for the other
modules in your MIDI chain using the MIDI port and the USB (Computer) port , then
select USB+MIDI+LOCAL.
Change Multis
e Change Multis parameter determines the exact timing of Multi changes when you
select a dierent Multi, either by a normal data entry method or via MIDI program change
commands.
Choose AllKeysUp to indicate that you want Multi changes to take place only when you’ve
released all currently held notes.
Choose Immediate to indicate that you want such changes to happen immediately when you
select the Multi.
Bank Select
e Bank Mode parameter determines the controller number with which MIDI Bank change
messages are received.
For MIDI Bank change messages, various manufacturers have chosen dierent MIDI
controller numbers. Most have chosen Ctl 0, Ctl 32, or both. You can set this parameter to
any of the following three settings:
Ctl 0
MIDI Bank change messages are sent with controller number 0.
Ctl 32
MIDI Bank change messages are sent with controller number 32.
Ctl 0 / 32
MIDI Bank change messages are sent with both controller numbers 0 and 32.