Kurzweil Flash Play PC4 - Bend up; down ST & Bend up; down CT; Entryprogchng; MIDI Program

Multi Edit Mode
MAIN Page
7-8
parameters will automatically change to match the Bank and Program numbers of the
Program that you select for Local Program. For example, if you choose Program 178, then
MIDI Bank will change to 1 and MIDI Program will change to 50.
Midi Program
e MIDI Program parameter determines the MIDI Program change message that the
currently selected Zone sends when the Multi is loaded. You can set this parameter to a
MIDI Program change message from 0 to 127.
When using the PC4 as a MIDI controller, sending a MIDI Program change message
(along with a MIDI bank change message) when a Multi is loaded ensures that the Program
loaded on the other sound modules in your MIDI chain is the Program that you want. For
example, if you’ve congured a Multi to work in a specic way with Program 32 in Bank5
of a connected sound module, then set MIDI Bank to 5 and MIDI Program to 32. is
way, whenever you load this Multi, the sound module will automatically load Program 32 in
Bank5.
Note: When you change the Program parameter, the MIDI Bank and MIDI Program
parameters will automatically change to match the Bank and Program numbers of the
Program that you select for Local Program. For example, if you choose Program 178, then
MIDI Bank will change to 1 and MIDI Program will change to 50.
EntryProgChng
e Entry Program Change parameter determines whether or not the currently selected
Zone will send a MIDI Program change message when the Multi is loaded. You can set this
parameter to either O or On. When set to On, the Zone will send a MIDI Program change
message with the Program specied for the MIDI Program parameter.
Bend Up / Down ST & Bend Up / Down CT
Bend Up ST and Bend Down ST sends a bend range message to an internal program or
a MIDI device, telling it how to dene subsequent pitch bend messages. You can set this
parameter to any value between 0 semitones and 127 semitones, or to Prog, which uses the
Bend Range Up / Down of the currently selected Program for the Zone. e value can be
entered numerically, and entering -1 will select Prog. (value that the Program would use in
Program Mode).
Bend Up CT and Bend Down CT lets you ne tune the value for Bend Up ST & Bend
Down ST (semitones). 100 cents equals one semitone, or one half step; you can set this
parameter anywhere between 0 and 100 cents.