Kurzweil Flash Play PC4 - Audio Input Mods in Program Mode; Program Tempo; Audio Input Mods in Multi Mode

Global Mode
MAIN1 Page
9-5
Audio Input Mods in Program Mode
To control Audio Input Mods in Program Mode, rst make sure the Global “AudioIn
Control” parameter is set to “Current Chan Ctl”. In Program Mode, the PC4’s physical
controllers send the MIDI CC numbers listed in the table below. If the selected Chain
contains Mods which use any of these MIDI CC numbers, eects parameters will be
controllable by using the physical controllers which have corresponding MIDI numbers.
Use the Chain editor if you wish to add Mods, remove Mods, or change their MIDI
assignments. Select the Chain eld and press the EDIT button to enter the Chain Editor. See
The MOD Pages on page 4-3 for details on editing Chain Mods.
PC4 Physical Controller MIDI CC Numbers
Mod Wheel (MIDI CC 1) Slider 4 (MIDI CC 23) Knob 3 (MIDI CC 72)
Knob 8 (MIDI CC 3) Slider 5 (MIDI CC 24) Knob 2 (MIDI CC 73)
CC Pedal 2 (MIDI CC 4) Slider 6 (MIDI CC 25) Knob 4 (MIDI CC 79)
Knob 9 (MIDI CC 9) Slider 7 (MIDI CC 26) Switch 1 (MIDI CC 80)
CC Pedal 1 (MIDI CC 11) Slider 8 (MIDI CC 27) Switch 2 (MIDI CC 81)
Slider 1 (MIDI CC 12) Slider 9 (MIDI CC 28) Switch 3 (MIDI CC 82)
Slider 2 (MIDI CC 13) Variation Button (MIDI CC 29) Switch 4 (MIDI CC 83)
Knob 5 (MIDI CC 14) Sw. Pedal 1a (MIDI CC 64) Switch 5 (MIDI CC 85)
Knob 6 (MIDI CC 17) Sw. Pedal 1b (MIDI CC 66) Switch 6 (MIDI CC 86)
Knob 7 (MIDI CC 18) Sw. Pedal 2a (MIDI CC 66) Switch 7 (MIDI CC 87)
Ribbon Section 1 (MIDI CC 21) Sw. Pedal 2b (MIDI CC 67) Switch 8 (MIDI CC 89)
Slider 3 (MIDI CC 22) Knob 1 (MIDI CC 71) Switch 9 (MIDI CC 90)
Audio Input Mods in Multi Mode
To control Audio Input Mods in Multi Mode, rst make sure the Global “Control”
parameter is set to “Current Channel Control”. On the Multi Edit Controls page, use the
Destination eld to assign a Multi controller to send the desired FX Mod CC number (see
CONTROLS Page on page 7-13 for details). e Zone used to send these CC numbers
must have a MIDI Channel which matches the current setting for the Multi’s “AuxFX Ch”
parameter. See Channel on page 7-7 and Aux FX Channel on page 7-28 for details.
Program Tempo
When this is set to Program, each program can be saved with a specic tempo, or be set to
use the system tempo. Tempo is used for the Arpeggiator as well as Tempo synced LFOs and
eects. is is set on the Program Edit Arp page (see Tempo on page 3-23). Per-program
Tempos can also be overridden by selecting System for the Global tempo parameter.