Kurzweil Flash Play PC4 - The DSP Control (DSP CTL) Page; Function-Parameter

Program Edit Mode
The DSP Control (DSP CTL) Page
3-53
The DSP Control (DSP CTL) Page
Use the DSP Control page to make coarse or ne adjustments to parameters of each DSP
block in the algorithm, and to adjust parameters for hard-wired modulation sources.
Function-parameter
e left-hand column of the DSP CTL page shows each function-parameter of the current
layer’s algorithm. You can coarsely adjust the selected function-parameter in these left-hand
elds.
e function-parameters are listed along the left-hand side of the DSP CTL page and the
DSP MOD page. e label of each function-parameter depends on its function in the
current program’s algorithm. For example, the Pitch function’s function-parameter is labeled
Pitch; and the two-block Lopass function’s function-parameters are labeled LP Frq and LP
Res.
Use each function-parameter to make coarse adjustments to each DSP function. Depending
on the parameter, values may be set in semitones (ST), cents (ct), decibels (dB) or Hertz (hz).
ese adjustments are also combined with any modulation applied to each DSP function on
the DSP CTL and DSP MOD pages.