Kurzweil Flash Play PC4 - The DSP Modulation (DSP MOD) Page

Program Edit Mode
The DSP Modulation (DSP MOD) Page
3-55
Negative VelTrk values will progressively decrease modulation depth for higher velocities.
For example, with a negative VelTrk value, playing a velocity of 0 causes no change in
modulation depth, playing each velocity further above 0 decreases the modulation depth by
the VelTrk amount.
The DSP Modulation (DSP MOD) Page
Use the DSP Modulation page to make coarse adjustments to parameters of each DSP block
in the algorithm, and to adjust parameters for selectable modulation sources.
Function-parameter
e left-hand column of the DSP MOD page shows each function-parameter of the current
layer’s algorithm. You can coarsely adjust the selected function-parameter in these left-hand
elds.
e function-parameters are listed along the left-hand side of the DSP MOD page and the
DSP CTL page. e label of each function-parameter depends on its function in the current
program’s algorithm. For example, the Pitch function’s function-parameter is labeled Pitch;
and the two-block Lopass function’s function-parameters are labeled LP Frq and LP Res.
Use each function-parameter to make coarse adjustments to each DSP function. Depending
on the parameter, values may be set in semitones (ST), cents (ct), decibels (dB) or Hertz (hz).
ese adjustments are also combined with any modulation applied to each DSP function on
the DSP MOD and DSP CTL pages.