Kurzweil Flash Play PC4 - CC Pedal Overrides; Rotary Override

Global Mode
MAIN2 Page
9-14
make sure the arpeggiator is turned on. Play the notes you wish to latch, press and hold the
assigned pedal, then release the notes. e notes will continue to arpeggiate until the pedal is
released. (e functionality may dier depending on the current arpeggiator Latch settings,
see Latch on page 3-23 for details.)
In Multi Edit Mode, if a pedal is selected which has a pedal override enabled in Global
mode, a message “Global Pedal Override is enabled” will display when that pedal is viewed to
remind you that the Global mode pedal override settings are being used instead of the Multi
mode pedal settings.
In Multi Edit Mode, setting a Pedal Mode to “O” will disable the override for that Pedal
in the selected Zone. It can be useful in Multi Mode to disable the Pedal Override for some
Zones. For example, you may want to use a Pedal Override to control Sustain in all Zones of
a Multi, but disable Sustain for one Zone.
When a Pedal Switch Override is used, the pedal will behave in Multi Mode as if the
OnValue and OValue are set to 127 and 0 respectively (this will not be shown in Multi Edit
Mode). When a Pedal Switch Override is set to Sustain, Sostenuto or Soft, the pedal will
behave in Multi Mode as if Pedal Type is set to Momentary (this will not be shown in Multi
Edit Mode). When set to Data Inc, Data Dec, Quick Acc Inc or Quick Acc Dec the pedal
will behave in Multi Mode as if Pedal Type is set to Toggle (this will not be shown in Multi
Edit Mode).
CC Pedal Overrides
In a similar manner to Switch Pedal Overrides, the CC Pedal Override parameters (CC1-2
Override) allow the Continuous Control Pedal assignments to be changed for all Programs
and Multis. e alternative assignments available for the CC Pedal Overrides include Mod
Wheel (MIDI CC 1), Foot/Wah (MIDI CC 4), Volume (MIDI CC7), Expression (MIDI
CC11) and Pressure.
In Multi Edit Mode, if a pedal is selected which has a pedal override enabled in Global
mode, a message “Global Pedal Override is enabled” will display when that pedal is viewed to
remind you that the Global mode pedal override settings are being used instead of the Multi
mode pedal settings.
Rotary Override
By default KB3 organ programs have the Slow/Fast speed control for the Rotary speaker
eect assigned to the Variation Button and the Sustain Pedal (SW1A). e Rotary Override
parameter allows you set the sustain pedal to function as sustain for all KB3 Programs,
instead of Rotary Slow/Fast. e Variation button will always control the Rotary speed,
regardless of this parameter’s setting.