Kurzweil Flash Play PC4 - The MIXER Page; Pan, Vol, Prog; Pan;Vol Initial Values

Song Mode
The MIXER Page
8-14
The MIXER Page
e Mixer page shows the current settings for the Program number, panning, volume, MIDI
destination, and Output selection each track (in groups of 8). e selected track number is
displayed in the upper right-hand corner of the screen. Use the CHANNEL/LAYER/ZONE/
TRACK or cursor buttons to change the currently selected track. To view each group of
tracks, press the 9-16 or 1-8 soft button.
Pan, Vol, Prog
Use the Pan, Vol, and Prog parameters to view or change the Panning (left/right stereo
placement), Volume, or Program of each track. Pan values range from 0 (left), 64 (center), to
127 (right). Volume values range from 0-127.
Pan/Vol Initial Values
Initial values are used to recall each track’s settings whenever a song is loaded. Initial values
for each track can be seen at the top of the Event page.
When recording to an unused track, the track’s Pan and Vol parameters will have an initial
value of “none”. An initial value of “none” allows you to try dierent Pan and Volume
settings for the track, without having the track return to specic initial values.
Once you have decided on the Pan and Volume settings for the track, you should apply these
settings as initial values so that they will be recalled the next time the song is loaded. To set
initial values, make sure the song is stopped, press the RECORD button to change the song
status to Rec Ready, select the desired initial values again (even if they are already selected),
then press the RECORD button again to change the song status to Stopped. Make sure to
save these initial values by saving the song before exiting song mode or selecting another
song.