Kurzweil Flash Play PC4 - Initial Program, Volume, Pan; Bar, Beat, and Tick

Song Mode
The EVENT Page
8-37
Initial Program, Volume, Pan
At the top of the event list for each track, you can view and change the initial program,
volume and pan settings for the current track. Initial values are needed in order for songs to
sound correct after being saved and recalled. If you do not want initial values, each of these
parameters can be set to NONE by entering -1 on the alphanumeric pad and then pressing
the Enter button.
Location
e rst column represents the Bar and Beat Locations of the dierent events in a song.
Scroll through the events on the selected track(s) with the Alpha Wheel or type a specic
Bar and Beat on the alphanumeric button pad to jump to events occurring on that Beat.
A quick way to jump to the End point in a track is to press 9999 and then Enter on the
alphanumeric button pad.
Bar, Beat, and Tick
Bar, Beat, and Tick are editable parameters for each event. ey determine when an event
happens relative to the other events within the song. Tick can be set from 0 to 959. See Beat
Subdivisions in Ticks on page 8-39 for a list of beat subdivisions in ticks.