Kurzweil Flash Play PC4 - Audioin FX Chain; Audioin Control; About Effects Chain Mods

Global Mode
MAIN1 Page
9-4
AudioIn FX Chain
When the AudioIn FX parameter is set to Yes, you can use the AudioIn FX Chain parameter
to select an FX chain to apply to the rear panel audio input jacks. If you wish to edit a Chain,
you can enter the Chain Editor by pressing the EDIT button (see Ch. 4 The Effects
Chain Editor for details).
When selecting an Audio Input Chain, the Chain may steal FX unit resources from other
channels in order to load if more resources are needed to load the Chain. When stealing
occurs, resources in higher numbered channels will be stolen rst, and in Program Mode
resources in the currently selected channel will be stolen last.
AudioIn Control
When the “AudioIn Control” parameter is set to “No Real Time Ctl”, the Eects Chain
Mods are disabled. Set the “AudioIn Control” parameter to “Current Chan Ctl” to enable
the Eects Chain Mods of the selected Chain.
In Program Mode, Mods assigned within the selected Audio Input Chain can be controlled
by the PC4’s physical controllers. See the About Eects Chain Mods section below for more
details.
In Multi Mode, if a Multi is selected which has its Audio Input Mode set to “Use Global
Mode Eects”, any Mods assigned within the selected Audio Input Chain can be controlled
by controllers assigned in a Zone set to the same MIDI channel as the current setting for the
Multi’s “AuxFX Ch” parameter. See the About Eects Chain Mods section below for more
details.
About Effects Chain Mods
Eects Chain Mods are modulation controls which can be assigned to the PC4’s physical
controllers. For example, an Eects Chain Mod assigned to a Slider can be used to adjust the
dry/wet eect mix, or control other parameters like reverb or delay time.
When the “AudioIn Control” parameter is set to “Current Chan Ctl”, Mods assigned within
the selected AudioIn FX Chain can be controlled by controllers sending the same CC
numbers from the currently selected Program or Multi.
To view the Mods of the selected AudioIn FX Chain, select the AudioIn FX Chain eld and
press the EDIT button to enter the Chain Editor, then go to the Chain Info page (see Ch.
4 The Effects Chain Editor for details).