Kurzweil Flash Play PC4 - FM Layer Page; Feedback; Oscillator Key Sync

Program Edit Mode
FM Layer Page
3-90
FM Layer Page
Transpose
Use the Transpose parameter to adjust tuning in semitones for all Operators in the layer.
Detune
Use the Detune parameter to adjust ne tuning for all Operators in the layer. is is useful
for creating a chorus eect by applying dierent Detune values to multiple FM layers which
are set to the same settings.
Feedback
Use the Feedback parameter to adjust the feedback level for the selected FM Algorithm.
Each algorithm shows a line determining the feedback path, in which the output of an
Operator is used as its own modulation source, or as a modulation source for Operators in
higher rows. Feedback is useful for creating square waveforms and noise.
Feedback can be set to values from 0-7, where 0 applies no feedback, 1 applies the least
feedback, and 7 applies the most feedback.
Oscillator Key Sync
Use the Oscillator Key Sync parameter to turn oscillator key sync o or on.
When Oscillator Key Sync is set to On, the oscillator in each FM Operator resets its phase
each time a note is played.