Kurzweil Flash Play PC4 - Bank Mode; MIDI Bank

Multi Edit Mode
MAIN Page
7-7
Channel
e Channel parameter determines the MIDI transmit and receive channel for the currently
selected Zone. You can set this parameter to any of the 16 MIDI channels (1-16).
You can assign dierent Zones to the same channel, but only one Program can be loaded in a
channel at a particular time. e Program loaded will be whichever program change message
is received last.
Bank Mode
e Bank Mode parameter determines the controller number used for transmitting MIDI
Bank change messages. When sending Bank change messages to external MIDI equipment,
you may have to adjust this setting depending on which controller numbers the equipment
responds to. Most equipment responds to controller numbers 0, 32, or both. e Kurzweil
K2600 it responds to controller 32, but is limited to 100 programs per bank.
You can set this parameter to any of the following:
None
MIDI Bank change messages are disabled.
Ctl0
MIDI Bank change messages are sent with controller number 0.
Ctl32
MIDI Bank change messages are sent with controller number 32.
Ctl0/32
MIDI Bank change messages are sent with both controller numbers 0 and 32.
K2600
MIDI Bank change messages are sent with controller number 32. (K2600 Program
numbers 0-99.)
Midi Bank
e MIDI Bank parameter determines the MIDI Bank change message that the currently
selected Zone sends when the Multi is loaded. You can set this parameter to a MIDI Bank
change message from 0 to 16383.
When using the PC4 as a MIDI controller, sending a MIDI Bank change message (along
with a MIDI Program change message) when a Multi is loaded ensures that the Program
loaded on the other sound modules in your MIDI chain is the Program that you want.
For example, if you’ve congured a Multi to work in a specic way with Program 32 in
Bank5 of a connected sound module, then set MIDI Bank to 5 and MIDI Program to 32.
is way, whenever you load this Multi, the sound module will automatically load Program
32 in Bank5. Pressing both Previous & Next buttons simultaneously will set this parameter
to the Bank number of the currently selected Local Program.
Note: When you change the Program parameter, the MIDI Bank and MIDI Program