Kurzweil Flash Play PC4 - Inputs; Num Blocks; Outputs

Program Edit Mode
The Wiring Algorithm (ALG) Page
3-52
To select a block for editing, move the cursor down the display until no parameter eld is
highlighted; then, using the < and > buttons, highlight a block to edit. Press the ^ button to
move the cursor back into the parameter elds, and then select a parameter to edit.
To edit the wiring signal path, select either an input of a block or an output of the entire
algorithm. By scrolling with Alpha Wheel or the Previous- and Next+ buttons, you can see
every possible wiring conguration for that selected signal path.
Inputs
Use the Inputs parameter to select the number of inputs for the currently selected DSP
block.
Num Blocks
Use the Num Blocks parameter to select the number of blocks for the currently selected DSP
block.
Outputs
Use the Outputs parameter to select the number of outputs for the currently selected DSP
block.
Output Mode
e Output Mode parameter determines the number of outputs from the algorithm. With
Output Mode set to Normal, the algorithm has one output. With Output Mode set to Sep.
L/R, the algorithm has two outputs, each of which is sent to a separate stereo channel.