Kurzweil Flash Play PC4 - Controlling Program Parameters from Multi Mode; CONTROLS Page; Switch Controllers

Multi Edit Mode
CONTROLS Page
7-13
CONTROLS Page
Use the Controllers Page to adjust controller settings for each Zone. e top right hand
corner of the display shows the currently selected Zone number. Use the CHANNEL/
LAYER/ZONE/TRACK buttons to select a Zone.
e PC4 has 2 types of controllers, switch controllers and continuous controllers. Each type
of controller has dierent parameters, see each section below for details.
Controlling Program Parameters from Multi Mode
To assign a Multi controller to a Program parameter, use the Destination eld. In the
Destination list, destinations that are assigned to parameters for the Program of the current
Zone will show the Program Parameter name next to the Destination number. Select one of
these destinations to control an assigned Program parameter.
You can also select the Destination eld, hold the ENTER button, then move the controller
that was assigned in Program Mode.
Switch Controllers
is section describes parameters for the following switch controllers:
• SW pedals 1 and 2
• VARIATION button
• ARP button
• LATCH button
• CONTROL buttons 1-9
• Key1-Key12