Global Mode
MAIN2 Page
9-13
Drum Remap
is parameter will remap all Drum programs to conform to the General MIDI (GM) drum
map, a standard drum map used in many keyboards and synthesizers.
When the Drum Remap is set to None, no remapping takes place in Program mode. When
the Drum Remap is set to GM, the PC4 remaps Drum programs to the GM drum map.
Pedal Noise
Some piano Programs have a Pedal Noise feature programmed into the sound. is
parameter allows you to turn the Pedal Noise o if you prefer not to use it. If it is on, it will
only activate noise on those Programs that have been programmed to use it.
Default Song
e Default Song parameter determines which song will be used as a new song template
when 0*New Song* is selected in Song mode. By selecting an edited user song, this allows
you to set custom settings for the new song template (such as metronome Program and
Count O settings).
Switch Pedal Overrides
e Switch Pedal Override parameters (SW1A-SW2B Override) allow the controller
assignments for the Switch Pedals to be changed for all Programs and Multis. (KB3 organ
programs have a separate override for the SW1A pedal, see the Rotary Override section below
for details.) e alternative assignments available for the Switch Pedal Overrides include the
standard pedal controls of Sustain, Sostenuto and Soft as well as Data Inc, Data Dec, Quick
Acc Inc and Quick Acc Dec, which can be used to change Programs, Multis or Quick Access
spots by using a pedal.
Use the Data Inc and Data Dec assignments (data increment/decrement) to select the next
or previous ID when you depress the pedal. If you are in Program mode, Data Inc and Data
Dec will select the next or previous Program. If you are in Multi mode, Data Inc and Data
Dec will select the next or previous Multi.
Use the Quick Acc Inc and Quick Acc Dec assignments (Quick Access increment/
decrement) to select the next or previous Quick Access spot when you depress the pedal. If
you do not have a Quick Access spot selected, Quick Acc Inc and Quick Acc Dec will select
the rst Quick Access spot, or the last spot that was selected since turning on the PC4.
Use the Arp On/O and Arp Latch assignments to easily control arpeggiator functions.
e Arp On/O assignment allows you to toggle the arpeggiator on and o by pressing
a switch pedal. e Arp Latch assignment allows you to latch held notes to be played by
the arpeggiator by holding down a switch pedal. When using the Arp Latch assignment,
To Next Page
Loading...
