Kurzweil Flash Play PC4 - Naming a User Program; Saving a User Program

Program Mode
Save User Programs
2-10
Naming a User Program
To rename the Program, rst press the RENAME soft button. e display shows the current
Program name.
Use the Category buttons, Alpha Wheel or Previous/Next buttons to change each character.
Use the Left/Right cursor buttons or <<< >>> soft buttons to move the cursor.
Press the +/- button to switch between upper and lower case characters.
Use the Insert button to insert a blank space. e selected character and all characters to the
right will move one space to the right.
Use the Delete button to delete the current character (all the characters to the right will move
one space to the left).
Saving a User Program
Press the Save button or Save soft button to complete the saving process, or press the Cancel
soft button to exit without saving. After successfully saving, the Program will be selected in
Program Mode.
To nd the Program again later, press the User button and scroll to the Program ID. You
can also nd the program by pressing the appropriate Category button and scrolling past
the factory programs. Lastly, you can press the Keypad button so that its LED is lit, type the
Program ID number, then press the Enter button.