Kurzweil Flash Play PC4 - Chain Edit Source Fields; Adding Physical Controllers; Adding MIDI CC Numbers

Program Edit Mode
The PARAMS Page
3-11
KB3 Editor: The AMP Page on page 3-112
• Source 1, Source 2
KB3 Editor: The LFO+, ARP and CC SEQ Pages on page 3-117
• RateCt, Trigger, Input a, Input b
Chain Edit Source Fields
The MOD Pages on page 4-3
• Source
FXLFO+ page on page 4-5
• RateCt, Trigger, Input a, Input b
Adding Physical Controllers
To assign a PC4 physical controller, select the source eld for the parameter, hold the
ENTER button and move the controller.
Adding MIDI CC Numbers
To assign a CC number to a source eld, enter a number from 1-31 or 64-95 with the
alphanumeric pad, then press Enter. A CC number for an external controller can also be set
by selecting the source eld for the parameter, holding the ENTER button, and sending a
CC value from the external MIDI controller.
Note: e PC4’s physical controllers each use one of the available MIDI CC numbers, so
you must choose one of the other available CC numbers when using an external MIDI
control source or else the parameter will also be controlled by a PC4 physical controller. See
the PC4 Physical Controller MIDI CC Numbers on page 3-7 for a list of CC numbers
used by the PC4’s physical controllers. Some MIDI CCs are also hard wired to control
certain program parameters or functions such as MIDI 5 (Portamento Time), MIDI 7
(Program Volume), MIDI 10 (Pan), MIDI 11 (Expression/Program Volume), MIDI 64
(Sustain), MIDI 66 (Sostenuto), so if you use one of these numbers the CC will always
perform the hard wired function, in addition to any other assignment you make.