Kurzweil Flash Play PC4 - Adding Parameters to the PARAMS Page

Program Edit Mode
The PARAMS Page
3-10
Adding Parameters to the PARAMS Page
To add parameters to the PARAMS page, a controller assignment must be made using a
source eld on one of the Program Edit or FX Edit pages. Controllable parameters each have
a source eld. All source elds are listed below:
VAST Program Source Fields
The FX Page on page 3-13
• Mod
The Layer FX (LYR FX) Page on page 3-16
• Aux1 Mod, Aux2 Mod
The KEYMAP Page on page 3-39
• Alt Control
The LAYER Page on page 3-44
• Enable
The DSP Modulation (DSP MOD) Page on page 3-55
• Source 1, Source 2, Depth Ctl
The OUTPUT Page on page 3-57
• Mod
Envelope Control on page 3-62
• Source
The LFO+ Page on page 3-66
• RateCt, Trigger, Input a, Input b
FM Operator Page on page 3-84
• Level Source 1, Level Source 2, Freq Source 1, Freq Source 2
FM Amp + Output Page on page 3-95
• Source 1, Source 2, Crossfade
FM Alt Input Page on page 3-98
• Source 1, Source 2
KB3 Program Source Fields
KB3 Editor: The PITCH Page on page 3-112
• Source 1, Source 2