Kurzweil Flash Play PC4 - Program Edit Source Names; PARAMS Page Parameter Destination; PARAMS Page Parameter Shared Assignments

Program Edit Mode
The PARAMS Page
3-12
Program Edit Source Names
When assigning a physical controller or CC number to a Program Edit source eld, the
source eld will show a default MIDI CC number (the destination), followed by the assigned
physical controller name or MIDI CC number (the control name). For example assigning
Slider 1 shows “12 Slider 1”, and assigning MIDI CC 5 shows “5 MIDI 5”).
Note: If a parameter assignment is changed on the PARAMS page using the Control
column, the Program Edit source eld will update the control name, while maintaining the
same destination number. For example, in a clear Program assign the DSP MOD page Pitch
Source 1 to “12 Slider 1”. A “Pitch” parameter will appear on the Parameters page, with its
Control set to Slider 1. On the PARAMS page, change Pitch Control column to Slider 2.
e DSP MOD page Pitch Source 1 eld will now show “12 Slider 2”.
PARAMS Page Parameter Destination
On the PARAMS page, press the EDIT button to see a Parameter’s Destination eld. A
parameter’s Destination is automatically set when the Parameter is created, and can not be
changed.
A PARAMS page Parameter will control any Program Edit or FX Edit parameter which has
it’s source eld set to the same destination number. When an assigned Program Edit source
eld is selected, you can jump to selecting the controlling PARAMS page parameter by
pressing the EDIT button.
PARAMS Page Parameter Shared Assignments
When assigning a physical controller or CC number to a source eld, a Parameter is
automatically added to the PARAMS Page with the name of the rst assigned Program Edit
parameter.
If you assign a source eld to a destination number that is already used by a parameter
on the PARAMS page, a new parameter will not be added to the PARAMS page. e
new assignment will share the existing Parameter on the PARAMS page (Name, Control
assignment and initial Value). e existing Parameter will control multiple assignments, but
the existing Parameter’s name will not change to reect this. You can edit the Parameter name
by selecting the Parameter and pressing the EDIT button to access the parameter edit page.
See Parameter Edit on page 3-9 for details.