Program Edit Mode
The DSP Modulation (DSP MOD) Page
3-56
Subpage Parameters
e right-hand side of the DSP MOD page shows a subpage with selectable modulation
sources for the selected function-parameter. To access the parameters on the subpage,
highlight the function-parameter you wish to edit, and then press the > button to move the
cursor into the subpage. e label of a function-parameter depends on its corresponding
function-block in the current layer’s algorithm.
Source 1
Use the Source 1 parameter to modulate the selected function-parameter with a physical
controller or other control source.
Depth
Use the Depth parameter to set the maximum modulation depth of Source 1.
When a Source 1 control source is at its minimum value, Source 1 will have no eect on the
function-parameter.
When a Source 1 control source is at its maximum value, Source 1 will apply the amount of
modulation set by the Depth parameter.
Source 1 control source values between the minimum and maximum will scale the amount
of modulation between no eect and the amount set by the Depth parameter
Source 2
Use the Source 2 parameter to modulate the selected function-parameter with a physical
controller or other control source.
DptCtl (Depth Control)
Use the DptCtl parameter to modulate the Source 2 modulation depth with a physical
controller or other control source.
When a DptCtl control source is at its minimum value, the Source 2 modulation depth will
be set to the value of the MinDepth parameter.
When a DptCtl control source is at its maximum value, the Source 2 modulation depth will
be set to the value of the MaxDepth parameter.
DptCtl control source values between the minimum and maximum will scale the Source 2
modulation depth between the values of the MinDepth and MaxDepth parameters.
MinDepth
Use the MinDepth parameter to set the minimum modulation depth of Source 2.
When a DptCtl control source is at its minimum value, Source 2 will apply the amount of
modulation set by the MinDepth parameter.
To Next Page
Loading...
