Kurzweil Flash Play PC4 - The KEYMAP Page; Keymap, Keymap 1, Keymap 2; Stereo

Program Edit Mode
The KEYMAP Page
3-39
The KEYMAP Page
Use the Keymap Page to select keymaps for the current layer of the Program, as well as other
keymap parameters. A keymap is a group of samples that can be played by the current layer.
Keymap, Keymap 1, Keymap 2
Assign a keymap to the current layer. Keymaps are collections of samples assigned to note
and velocity ranges. With the Keymap parameter selected, press the EDIT button to enter
the Keymap editor (see Ch. 5 Keymap and Sample Editing for details).
When a DSP oscillator is being used as a layer sound source on the ALG page, the layer’s
current keymap will apply the volume adjustment value of each sample in the keymap to
each note played by the oscillator within those sample keyranges. To prevent this, select
Keymap 999 Silence.
When a DSP oscillator is being used as a layer sound source on the ALG page, and a layer’s
Amp Envelope Mode is set to Natural, the natural envelope of each sample in the layer’s
current keymap will be applied to each note played by the oscillator within those sample
keyranges. To prevent this, select Keymap 999 Silence or set Amp Envelope Mode is set to
User.
Stereo
Use the Stereo parameter when using stereo samples. When the Stereo parameter is set to
On, the Keymap 1 and Keymap 2 parameters appear. e KEYMAP page parameters will
aect both keymaps. When the Stereo parameter is set to On, the OUTPUT page for the
current layer will show an additional Pan parameter.