Kurzweil Flash Play PC4 - Arpeggiator Step Sequencer Mode Parameters; Number Steps

Program Edit Mode
The Arpeggiator (ARP) Page
3-33
Arpeggiator Step Sequencer Mode Parameters
In Step Sequencer mode, the ARP page will give you the ability to create a unique
Arpeggiator pattern step-by-step.
Select a parameter using the up/down navigation buttons. To change steps, select the Step#
parameter, then press the left or right navigation buttons.
Colored oval graphics provide a quick visual interpretation of the Step Sequence:
• Color = Note number.
• Height = Velocity level.
• Width = Duration.
• e line under each oval changes length depending on the Beats value for the current
step.
Number Steps
Use the Number Steps parameter to set the number of steps in the current sequence.
Step#
e Step# parameter shows the number of each step in the sequence, and can be used to
navigate between the steps.
Note
Note values create the shift pattern for the Step sequence. Notes are specied in half-steps
from the last latched note (represented as 0). us, this series of notes: 0, 4, 7 will play a triad
in sequence. Note values can range from -128 to +127, with negative numbers shifting below
the latched note.