Kurzweil Flash Play PC4 - Preampresp; Exp Pedal; Leakage; Leakmode

Program Edit Mode
KB3 Editor: The COMMON Page
3-108
PreampResp
Set this parameter On or O to enable or disable the preamp+expression pedal part of
the KB3 program. Turning this On (the default) makes KB3 programs function like stock
organs. e expression pedal in this case is more than a volume pedal; it actually functions
like a “loudness control,” varying the frequency response to compensate for the ear’s
sensitivity at dierent volumes. In addition, the preamp provides a de-emphasis curve to
compensate for the built-in tone wheel volume pre-emphasis. Turning preamp response
O emulates organs that have been modied to have a direct out (before the preamp and
expression pedal). Set PreampResp to O to disable the volume pedal.
Exp Pedal
Use this parameter to set which rear panel CC Pedal input will control volume for the
current KB3 program. With a setting of Expression/Foot, volume can be controlled by a CC
pedal plugged into either the rear panel input labeled CC Pedal 1 (volume), or the rear panel
input labeled CC Pedal 2. With a setting of Expression, volume can be controlled by a CC
pedal plugged into the rear panel input labeled CC Pedal 1 (volume). With a setting of Foot,
volume can be controlled by a CC pedal plugged into the rear panel input labeled CC Pedal
2. With a setting of None, volume control from both CC pedal inputs is disabled.
Leakage
is parameter controls the level of the simulated crosstalk and signal “bleed” of adjacent
tone wheels in the model. is is provided to help “dirty up” the sound to make it a bit more
realistic. A setting of -96 dB gives the purest tones; other values add more simulated leakage.
is level is scaled by the drawbar levels, as well as the expression pedal level.
LeakMode
is parameter selects between dierent leakage models, determining which leakage
harmonics are emphasized. TypeA provides an overall tone wheel leakage, with all tone
wheels leaking a small amount. TypeX, TypeY, TypeZ, and TypeR emulate dierent degrees
of drawbar leakage, where the leakage components correspond to the nine drawbars, instead
of all the tone wheels.
VolAdjust
Use the VolAdjust parameter to adjust the pre-insert FX volume of the program. (Use the
Output Gain parameter to adjust the overall post-FX volume of the program.)
Bend Range Up, Bend Range Down
Respectively control the upward and downward pitch bend ranges of the KB3 program.